Demonstration Software; Features - STMicroelectronics UM1079 User Manual

Features

2.5

Demonstration software

The demonstration software, preloaded in the board Flash memory, uses the built-in I
measurement feature to automatically measure and display the MCU consumption on the
LCD (in Run and Low-power modes).This software also allows to demonstrate touch
sensing functionalities such as linear touch sensor or touchkeys.
The latest version of this demonstration source code and associated documentation can be
downloaded from www.st.com/mcu
3 Features
The 32L152CDISCOVERY offers the following features:
•
An STM32L152RCT6 microcontroller (256 Kbyte Flash memory, 32 Kbyte RAM,
8 Kbyte data EEPROM) in a 64-pin LQFP package
•
On-board ST-LINK/V2 with selection mode switch to use the kit as a standalone
ST-LINK/V2 (with SWD connector for programming and debugging)
• Board power supply: through USB bus or from an external 3.3 or 5 V supply voltage
•
External application power supply: 3 V and 5 V
• I
DD
•
LCD
–
–
• Four LEDs:
–
–
–
• Two pushbuttons (user and reset)
•
One linear touch sensor and four touchkeys
• An extension header for LQFP64 I/Os for quick connection to prototyping board and
easy probing
The STM32L-DISCOVERY offers the same features except an STM32L152RBT6
microcontroller (128 Kbyte Flash memory, 16 Kbyte RAM, 4 Kbyte data EEPROM) in a 64-
pin LQFP package.
8/38
current measurement
DIP28 package
24 segments, 4 commons
LD1 (red/green) indicating USB communication
LD2 (red) indicating that 3.3 V power supply is ON
Two user LEDs, LD3 (green) and LD4 (blue)
DocID018789 Rev 4
UM1079
DD