Table of Contents
Advertisement
Operation for switching from "Position control mode to "Continuous
operation to torque control mode" automatically
When the condition set in "
Control mode auto-shift parameter
operation to torque control mode automatically, set the control data necessary in
continuous operation to torque control mode, "
", and "
selection
Cd.154
operation to torque control mode" in "
Switching request" in "
In this case, the current control is continued before the setting condition is
satisfied after control mode switching request, and "2: Waiting for the completion
of control mode switching condition" is set in "
When the set condition is satisfied, "1: Position control mode - continuous
operation to torque control mode, speed control mode - continuous operation to
torque control mode switching" is set in "
"0" is stored in "
Cd.138
" after completion of switching.
switching status
If "
Control mode auto-shift parameter
Cd.154
"Outside control mode auto-shift switching parameter range" (error code: 551) will
occur at control mode switching request, and the current processing stops. (The
operation stops according to the setting in "
during the positioning control. The mode is switched to position control during the
speed control, and the operation immediately stops.)
Control mode auto-shift selection
Cd.153
" is satisfied, to switch the mode to continuous
Control mode auto-shift parameter
Cd.139
Control mode switching request
Cd.138
Md.124
Control mode switching request
" is outside the setting range, an error
Pr.39
12 - 20
Chapter 12 Expansion Control
" and "
Control mode auto-shift
Cd.153
", set "30: Continuous
", and then set "1:
Control mode setting
".
Control mode switching status
Md.124
Control mode switching status
" and "
Control mode
Md.124
Stop group 3 sudden stop selection
Cd.154
".
".
"
Advertisement
Table of Contents
