Table of Contents
Advertisement
Wiring the near-point dog
The "external input signal of QD77MS", "external input signal of the servo
amplifier" or "buffer memory of QD77MS" can be selected by "
" as the near-point dog.
signal selection
When the "buffer memory of QD77MS" is selected, the wiring differs according to
the Input module used.
QD77MS
DOG
COM
Fig. 8.1 Wiring when using the near-point dog
OPR sub functions
Refer to Section 3.2.5 "Combination of QD77MS main functions and sub functions"
for details on "sub functions" that can be combined with OPR control. Also refer to
Chapter 13 "Control Sub Functions" for details on each sub function.
[Remarks]
The following two sub functions are only related to machine OPR.
Sub function name
OPR retry function
OP shift function
: Combination possible,
When an OPR is not required
Control can be carried out ignoring the "OPR request flag" (
systems that do not require an OPR.
In this case, the "OPR parameters (
initial values or a value at which an error does not occur.
OPR from GX Works2
"Machine OPR" and "fast OPR" can be executed from the test function of the
GX Works2.
Refer to the "Simple Motion Module Setting Tool Help" of GX Works2 for details on
OPR from the GX Works2.
24VDC
Machine OPR
: Restricted,
: Combination not possible
Pr.43
to
8 - 4
Chapter 8 OPR Control
External input
Pr.80
Servo amplifier
DI3
(DOG)
DICOM
24VDC
Fast OPR
Md.31
Status: b3) in
Pr.57
)" must all be set to their
Reference
Section 13.2.1
Section 13.2.2
Advertisement
Table of Contents
