Option board
Description
Option board, HDMI
Option board, serial port
Option board, DisplayPort
Option board, USB Type-C
Option board, VGA
An option board can be installed near the back of the system board that provides an additional connector on
the rear I/O panel.
NOTE:
The image in this section shows a serial port expansion board.
To remove the option board:
1.
Prepare the computer for disassembly
2.
Remove the top cover
3.
Remove the fan
4.
Remove the heat sink
5.
Remove the two Phillips screws (1) that secure the board to the system board.
6.
Lift to disengage the board from the system board connector (2), and then remove the option board
from the computer (3).
To install the option board, reverse the removal procedures.
(Preparation for disassembly on page
(Top cover on page
(Fan on page
42).
(Heat sink on page
21).
43).
20).
Option board
49