Internal Wlan Antenna Cable Removal/Installation - HP EliteDesk 800 G3 Maintenance And Service Manual

Internal WLAN antenna cable removal/installation

The antennas route from the WLAN module to the cable connectors on the front and the rear of the computer.
To install the antennas:
1. Prepare the computer for disassembly
2. Remove the top cover
3. Remove the thermal sensor
4. Remove the memory modules
5. Remove the hard drive
6. Remove the hard drive cable
7. If your model is an EliteDesk 800 G3, remove the secondary fan
models only) on page
8. Remove the drive cage
9. Remove the fan
10. Remove the heat sink
11. Remove the solid-state drive (if installed)
12. Remove the WLAN module (if installed)
13. Remove the option board (if installed)
14. Remove the system board
15. Remove the antenna cables from the clips in their routing paths along the chassis floor.
(Preparation for disassembly on page
(Top cover on page
(Thermal sensor on page
(Memory on page
(Hard drive on page
(Hard drive cable on page
32).
(Drive cage on page
(Fan on page 42).
(Heat sink on page
(WLAN module on page
(Option board on page
(System board on page
21).
24).
25).
29).
31).
(Secondary fan (EliteDesk 800 G3 65 W
33).
43).
(M.2 PCIe solid state drive (SSD) on page
36).
49).
50).
Internal WLAN antenna cable removal/installation
20).
34).
53