Replacing The Photoconductor Unit - Ricoh Aficio CL7000 Operating Instructions Manual

Replacing the Photoconductor Unit

If "Replace Black PCU (Type F)" ap-
pears on the display, replace the black
photoconductor unit.
Replace Black
PCU (Type F)
If "Replace Color PCU (Type A)" ap-
pears on the display, replace the three
color photoconductor units.
Replace Color
PCU (Type A)
Note
❒ The replacement procedure for the
third photoconductor unit from
the top left will be described. The
procedure is the same for all four
photoconductor units.
A A A A
Turn off the power, and then un-
plug the power cable.
B B B B
Slowly open the front cover of the
printer, remove the green screw-
driver.
Reference
p.1 "Using the Screwdriver"
C C C C
Turn the green lever counter-
clockwise.
D D D D
Loosen the two screws fastening
the inner cover, using the provid-
ed screwdriver.
You cannot remove these two
screws.
E E E E
Lift the inner cover until it clicks
into place and holds.
The photoconductor units are in-
stalled as shown. Starting from the
upper left, the units are attached in
the order of black (K), yellow (Y),
cyan (C), and magenta (M).
ZHXH410J
Replacing the Photoconductor Unit
1
ZHXH430J
ZHXH460J
ZHXH470J
11