Ricoh Aficio CL7000 Operating Instructions Manual page 82

Troubleshooting
Messages
Reset PCU Correctly Yel-
low/Magenta/Cyan/Black
Reset Toner Yellow/Magen-
ta/Cyan/Black
Reset Tray # Correctly
Reset Waste Oil Bottle correct-
4
ly
Reset Waste Toner Correctly
Resetting Job...
RPCS Graphic Error
RPCS Memory Overflow
RPCS Syntax Error
SC XXX-X Power Off On
If Error Reoccur Call Service
Setting change in process
SSID not entered
Staple Cancelled
Toner is Almost Empty: Black The printer is almost out of
Toner is Almost Empty: Cyan The printer is almost out of
76
Description
The indicated photoconductor
unit(s) is/are not set correctly,
or not set.
The indicated toner cartridge
is not set correctly.
The indicated paper input
tray is not set correctly, or not
set.
The waste oil bottle is not set
correctly, or not set.
The waste toner bottle is not
set correctly, or not set.
Job is being reset.
The graphic is not initialized
because graphic memory was
not reserved.
Printer memory is not initial-
ized because CDC memory
was not reserved via system
call.
The printer identified a syntax
error. This error results from
data corruption caused by
transmission problems, inter-
ruption, data transmission
from other drivers, etc.
Turn the power off and then
on. If the message appears
again, contact your sales or
service representative.
The settings are being
changed.
This message appears if the
SSID has not been entered.
The Staple feature has been
canceled.
toner (K).
toner (C).
Recommended Action
Set the indicated photocon-
ductor unit(s) correctly.
See p.11 "Replacing the Pho-
toconductor Unit".
Set the indicated toner car-
tridge(s) correctly.
See "Installing the Toner Car-
tridge", Setup Guide.
Set the indicated paper input
tray correctly.
Contact your sales or service
representative.
Set the waste toner bottle cor-
rectly.
Wait a while.
Replace installed memory.
Replace installed memory.
Be sure to use the correct driv-
er.
Turn the power off, and then
on. If the message appears
again, contact your sales or
service representative.
Wait a while.
Enter the SSID.
Check the paper orientation
and layout is properly set, and
make sure required settings
for the finisher are selected.
Prepare a replace the toner
cartridge (K).
Prepare a replace the toner
cartridge (C).