Table of Contents
Advertisement
Troubleshooting
F
Close the front cover. Press the
center of the cover until it locks
securely into place.
4
The "Add Toner" message clears
from the panel display and the
printer starts warming up.
Replacing the Photoconductor
Unit
The message shown below indicates
that the photoconductor unit is ap-
proaching the end of its life.
IPDL-C
Change PCU
You can still continue to use the cur-
rent photoconductor unit if you are
satisfied with the quality of the out-
put being produced by the printer.
When the printed image starts look-
ing soiled (horizontal lines along the
edges of the page, for example), re-
place the photoconductor unit as
soon as possible.
68
R WARNING:
• Do not incinerate the photo-
conductor unit. Toner dust
might ignite when exposed to
an open flame.
• Disposal can take place at our
authorized dealer or at appro-
priate collection sites.
• If you dispose the used photo-
conductor unit yourself, dis-
pose of it according to your
local regulations.
ZDGH012J
R CAUTION:
• When accessing the inside of
the machine, do not touch any
sections other than those
specified in this manual. If you
do, it might result in receiving
a burn or injury.
• Do not open the front cover
when the paper tray is pulled
out halfway. If you do, it might
cause a personal injury.
Important
❒ Exposing the photoconductor unit
to light for too long can reduce its
performance. Replace the unit as
quickly as possible.
❒ Do not touch the surface of the
photoconductor unit. If you do, it
may damage the photoconductor
unit and reduce the print quality.
❒ Do not expose the photoconductor
unit to a light source greater than
800 luxes for more than two min-
utes. If you do, the photoconductor
unit will be damaged and the print
quality might be reduced.
Advertisement
Table of Contents
