Setup Error Messages - Toshiba e-studio 45 Operator's Manual

C
C-5 Troubleshooting
Mac OS users may fail to see the GA-1040 if a network administrator has assigned it to
a different zone, or has added zones where previously there were none.
If you have configured the GA-1040 and set up client computers and network servers
according to guidelines in the Configuration Guide and Getting Started, try printing a
Test Page (at the Command WorkStation, choose Print Pages from the File menu).
If you are able to print the test page but still can't print a file from a remote computer,
contact the system administrator to troubleshoot the network connection.
If you are unable to connect to the GA-1040, and you cannot print the Test Page,
check the GA-1040's touch panel display.
If this happens:
The display is completely
blank.
The copier is not in
Standby mode.
You still cannot print a
Test Page.

Setup error messages

For information on Setup error messages, see the Configuration Guide.
Try this:
Check the copier's Standby function. If the copier is in
Standby mode, press the Standby key to see any messages on
the display.
The copier's Automatic Power-Off function may have shut
down the copier.
Turn the copier on, and then try printing a Test Page again
when the copier has warmed up.
Make a copy. If you can make a copy, restart the GA-1040,
and when you see Online, try printing a Test Page again. If
the Test Page still fails to print, contact your authorized
service/support center.