Error Detection - Toshiba KD1009 Manual

3.2 Error Detection

[A] Jam detection
(1) Paper jams (E15), (E16) and (E32, E34, E35) [DP4500/3500: (E15, E16) (E30~E36)] occurs in the
following cases.
a. Feed sensor (S2)/(S3) is not turned ON within 0.4 second after the feeding is started.
b. The leading edge of the paper does not pass the feed sensor (S2)/(S3) in the transport path within
a fixed time.
(2) Open the side cover of the paper feeder and remove all the paper remaining on the transport path and
close the side cover to clear the jammed paper. If either of the feed sensors (S2)/(S3) is still ON when
the side cover is closed, it is determined that there is still paper on the transport path and the paper jam
status is not canceled.
(3) When a paper jam occurs in the paper feeder during multiple copying, the sheet that was fed before the
jam is copied normally.
[B] Call Service
(1) The tray is raised when the power is turned ON or the cassette is inserted or removed.
If the tray-up sensor (S4)/(S5) is not turned ON within 8 (DP4500/3500: 12 seconds) seconds after the
tray has started to raise, a message to the effect that the selected cassette of that level cannot be
used is displayed in the control panel.
(2) The state (1) are cleared by removing the cassette. (This state cannot be cleared by opening and
closing the side cover)
KD-1009 GENERAL OPERATION 3 - 2 October 2000 © TOSHIBA TEC