1.1.6 Web User Interface Programming
1.1.6.4 Accessing the Web User Interface
The unit can be configured from the Web user interface.
To access the Web user interface
1.
Open your Web browser, and then enter "http://" followed by the unit's IP address into the address field
of your browser.
a.
When the IP address is 192.168.0.1 (IPv4), access the following URL.
http://192.168.0.1/
b.
When the IP address is 2001:db8:1f70::999:de8:7648:6e8 (IPv6), access the following URL. With
IPv6, the IP address is enclosed in square brackets ("[" and "]").
http://[2001:db8:1f70::999:de8:7648:6e8]/
Note
•
To determine the unit's IP address, perform the following operations on the unit:
1.
In standby mode, tap
2.
Tap "System Settings".
3.
Tap "Status".
4.
Tap
5.
Tap "IP Address". (IPv6 only)
2.
For authentication, enter your ID (username) and password, and then click OK.
Notice
•
The default ID for the User account is "user", and the default password is blank. The ID cannot be
changed from the Web user interface, but it can be changed through configuration file
programming.
•
When you log in as User to the Web user interface for the first time, the [User Password
Settings] screen (→ see 4.4.2 User Password Settings) will be displayed. Enter a new
password, and then perform authentication again with the new password to log in to the Web user
interface.
•
The default ID for the Administrator account is "admin", and the default password is "adminpass".
The ID cannot be changed from the Web user interface, but it can be changed through
configuration file programming.
3.
The Web user interface window is displayed. Configure the settings for the unit as desired.
4.
You can log out from the Web user interface at any time by clicking [Web Port Close].
Controls on the Window
The Web user interface window contains various controls for navigating and configuring settings. The
following figure shows the controls that are displayed on the [Basic Network Settings] screen as an
example:
18
Administrator Guide
or
or
to select "IPv4 Settings"/"IPv6 Settings".
to select "System Settings".
Document Version 2016-05