Maintenance - Makita TM30D Instruction Manual

NOTE: Using a test material sample to try is recom-
mendable to determine a correct orbital stroke rate
suitable for your work.
NOTE: Use a sanding paper with the same grit until
sanding the whole workpiece is completed. Replacing
a sanding paper with different grit sanding paper may
not get a fine finish.
Dust extraction attachment
Optional accessory
CAUTION:
Do not use the dust extraction
attachment when sanding metal. Sucking spark
and hot particle results in smoking and ignition.
Fig.13
► 1 . Dust nozzle 2. Joint 3. Dust attachment 4. Nozzle
band 5. Holes in the tool 6. Felt ring 7. Sanding pad
8. Application tool installation bolt
1. Install joint, dust nozzle and dust attachment.
2. Install the nozzle band on the tool so that its pro-
trusions fit in the holes in the tool to secure it.
3. Put the felt ring and the sanding pad on the dust
attachment and then secure them with the application
tool installation bolt.
To perform cleaner operation, connect a vacuum
cleaner to the tool. Connect a hose of vacuum cleaner
to the dust extraction attachment (optional accessory).
Fig.14

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
9 ENGLISH