Operation; Cutting, Sawing And Scraping - Makita TM30D Instruction Manual

3
1
Fig.8
► 1 . Sanding pad 2. Tighten 3. Sanding paper
To remove the sanding paper, raise its end and peel it off.
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
Fig.9
► 1 . Application tool installation bolt 2. Holes in the
application tool 3. Adapter (required for some appli-
cation tools) 4. Protrusions of the tool flange
Hex wrench storage
Fig.10
► 1 . Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
2

OPERATION

WARNING:
Before starting the tool and
during operation, keep your hand and face away
from the application tool.
CAUTION:
Do not apply excessive load to the
tool which may cause a motor lock and stop the tool.
CAUTION:
Do not operate the tool with press-
ing the battery cartridge against the tool.

Cutting, sawing and scraping

CAUTION:
Do not move on the tool forcibly in
the direction (eg. towards either side) of tool appli-
cation with no cutting edge. It may damage the tool.
Fig.11
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE: Forcing or excessive pressure on the tool may
reduce efficiency.
NOTE: Before cutting operation, it is recommended to
preset the orbital stroke rate 3 - 5.
Sanding
CAUTION:
Do not reuse a sanding paper used
for sanding metal to sand wood.
CAUTION:
Do not use a worn sanding paper
or sanding paper without grit.
Apply a sanding paper on the workpiece.
Fig.12
8 ENGLISH