Winterizing - Sundance Spas Maxxus Owner's Manual

880 SERIES
5. Do not drag or use the flaps/skirt or the cover lock straps to remove
the cover.
6. Use only recommended cover lift systems.
7. Use only chemicals and cleaners recommended by Sundance Spas.
8. Remember to keep spa covered when not in use. Maintaining proper
water levels assures efficient operation and efficient electrical usage.
9. Do not expose your spa to the sun for extended periods of time as
UV rays can damage the interior surface.
10. Use caution when removing cover. Before removing cover, assure all
locks have been released to avoid lock breakage and/or cover strap
damage.
13.8

Winterizing

Your Sundance hot tub is designed to automatically protect itself against
freezing when operating properly. During periods of severe freezing
temperatures, you should check periodically to be certain that the electri-
cal supply to the hot tub has not been interrupted. In extreme bitter cold
weather, less than 32°F (0°C), program the circulation pump to run for 24
hours to prevent freezing.
If you do not intend to use your hot tub, or if there is a prolonged power
outage during periods of severe freezing temperatures, it is important
that all water be removed from the hot tub and equipment to protect
against damage from freezing.
Expert winterization of your spa is highly recommended, contact
your authorized Sundance Spas dealer. In emergency situations,
damage can be minimized by taking the following steps:
CAUTION: TURN OFF POWER TO HOT TUB!
1. Follow the directions (Section 13.3) for draining the hot tub.
2. Turn the massage/diverter selector(s) to the middle combo position
to allow the water in the plumbing lines to drain, page 52.
3. Turn the waterfall valve(s) to the open position to allow the water in
the plumbing lines to drain, page 53.
4. As the water level drops below the seats, use whatever means
necessary to get the water out of the recessed seating areas and
into the footwell, such as a wet/dry vacuum.
5. Open all the air controls and leave them open until you resume use
of the spa, page 53.
6. When the water level ceases to drop, use whatever means available
to remove any remaining water from the footwell, such as a wet/dry
vacuum.
7. Remove the equipment-side cabinet panels and locate the drain
plugs in the front of each pump (Figures A and B, pages 14-15).
Remove these plugs to allow the water to drain out of the pumps and
heater.
Note: Approximately 1 to 2 gallons will be released during this proce-
dure. Use a wet/dry vacuum or other means to keep this from flooding
the equipment compartment. Replace the drain plugs.
Page 72