Programming Instructions; User Codes - CODELOCKS CL2000 Programming And Operating Instructions

PROGRAMMING INSTRUCTIONS

*First change the factory Master Code
#1234 - see program 10. If the Master
or Sub-Master Code is entered 3 times
consecutively without performing a
programming function, a penalty time of
10 seconds is activated.
Note: On the CL2000 and CL4000 locks
the at the bottom of
the keypad acts as the # button. The
Master Code and Sub-Master Code
MUST always start with #.
Codes can only be the same length
as the Master Code. A
Key Sequence opposite indicates
LED illumination.
IF ENTERED, A SUB-MASTER CODE CAN
BE USED INSTEAD OF THE MASTER
CODE FOR ALL PROGRAMS EXCEPT
PROGRAMS 10 AND 12.
• or • in the
ENTER NEW USER CODE - PROGRAM 01
#Master Code • 01
New Code (eg 4321)
Result: New code 4321 entered at User Code ID 05
(• when user enters code)
SUSPEND USER CODE - PROGRAM 02
#Master Code • 02
Result: User Code at ID 05 suspended
(•• when user 05 enters code)
RESTORE USER CODE - PROGRAM 03
#Master Code • 03 •User Code ID (eg 05)
Result: User Code at ID 05 restored
(• when user 05 enters code)
SUSPEND ALL USER CODES - PROGRAM 04
#Master Code • 04
Result: All User Codes suspended
(•• when all users enter code)
RESTORE ALL USER CODES - PROGRAM 05
#Master Code • 05
Result: All User Codes restored
(• when all users enter code)
CHANGE UNLOCK TIME - PROGRAM 06
#Master Code • 06
Result: After code entry the lock will unlock for the set time
(Factory pre-set time is 4 seconds)
6
• User Code ID (eg 05) •
••
• User Code ID (eg 05) ••
••
••
••
• enter open time (range 2 - 9 secs) ••