Changing Key Bypass Functions - CODELOCKS CL2000 Programming And Operating Instructions

5
Test the key operation. If the key is difficult to insert or
tight when turning, then the cap maybe too tight. Loosen
the cap one notch at a time and try the key again. If the
key inserts and turns OK, but is difficult to remove, then
the cap may be too loose. Tighten up the cap one notch
at a time. Adjust the cap until the key inserts, turns and
removes easily.
6
With key turned 90º clockwise replace cylinder,
cylinder cover and handle.
k
CAUTION!
DO NOT INSERT THE KEY IN THE CYLINDER
ONCE YOU HAVE REMOVED THE SCREW-CAP

CHANGING KEY BYPASS FUNCTIONS

Storeroom Function tailpiece allows key to turn 90º
clockwise to enable handle to retract the latch - this is the
factory fitted function.
Classroom Function tailpiece allows key to turn 90º clockwise
and be removed leaving the handle engaged in Code Free Mode.
Code Free Mode is cancelled by turning key 90º anti-clockwise.
THESE TAILPIECES WILL FIT MOST SCREW-CAP CYLINDERS
FROM OTHER MANUFACTURERS
5