Ebm Installation - Powerware 9125 Installation Manual

P30 Installation Guide

EBM Installation

A small amount of arcing may occur when connecting an EBM to the UPS. This is normal and will not
harm personnel. Insert the EBM cable into the UPS battery connector quickly and firmly.
If you are installing the optional EBM(s), use the following steps:
NOTE
EBM, the battery connector cover must be installed as a safety precaution.
NOTE
the EBM cable cover must be installed as a safety precaution.
10
1.
The UPS has a battery connector cover that must be removed before installing the
EBM(s). Remove the cover from the rear panel as shown in Figure 16.
Keep the battery connector cover for future use. If the UPS is stored or used without an
2.
Remove the cover from the EBM cable as shown in Figure 17.
Keep the EBM cable cover for future use. If the EBM is stored or removed from the UPS,
3.
Plug the EBM cable into the UPS battery connector (see Figure 18).
®
Powerware 9125 (9910 P30) Installation Guide for IBM
C A U T I O N
Battery Connector Cover Screws
Figure 16. Battery Connector Cover
EBM Cable with Cover
Figure 17. EBM Cable Cover
Applications S 164201544 Rev A Final 29-Jun-2004
®