Ups And Fc 6570 Pdm - Powerware 9125 Installation Manual

P30 Installation Guide

UPS and FC 6570 PDM

NOTE
the protected device(s).
If you are installing a UPS and a PDM and non-redundant power to the device(s) is desired, plug
all the equipment into the PDM output receptacles (see Figure 28 on page 19) using the
original device power cords (see Table 11 for IBM plug types supported). Distribute the load
evenly between the rows of receptacles on the PDM.
If you are installing a UPS and a PDM and dual-redundant power to the device(s) is desired,
plug the minimum number of power cord(s) required to operate the device into the PDM
output receptacles (see Figure 28 on page 19) using the original device power cords (see
Table 11 for IBM plug types supported). Then plug the remaining (redundant) power cord(s)
into a non-UPS protected output receptacle (e.g., PDU or mains) or a second UPS with a PDM
using device power cords. Distribute the load evenly between the rows of receptacles on the
PDM.
NOTE
Suppression (TVSS).
Table 11. FC 6570 PDM Plug Types Supported
NOTE
change/order the plug type on the equipment to match the plug types supported.
If you have questions about implementing non- or dual-redundant power, the following options
are available:
14
The PDM allows a UPS to be removed for service while providing conditioned power to
The redundant power source must be protected with Transient Voltage Surge
IBM Plug Type
4
5
29
10
If the IBM plug type selected with the equipment to be protected is not contained in this table,
www.oem.powerware.com/ibm-ups/pdf/nemadiagm.pdf
www.oem.powerware.com/ibm-ups/pdf/iecdiagm.pdf
submit your question to "Ask the Expert" at www.oem.powerware.com/ibm-ups/
contact the IBM office or Business Partner servicing your account
®
Powerware 9125 (9910 P30) Installation Guide for IBM
Description
NEMA 5-15P
NEMA 6-15P
NEMA 6-20P
NEMA L6-15P
Applications S 164201544 Rev A Final 29-Jun-2004
®
Quantity Supported
2
4 4
2