Day And Night Settings - D-Link DCS-7110 User Manual

Configuration
Switch to B/W in Night Mode: Select to automatically enable the camera to switch to
B/W night mode.
IR Cut Filter: The IR-Cut Removable (ICR) filter mechanically switches between two
different sensor filters. It provides the best light conditions both during the day and night.
The options are:
• Auto Mode: The camera automatically switches between day and night mode by
judging the level of ambient light. This mode is accessible only when the exposure
mode is set to Auto.
• Day Mode: In this mode the camera switches the IR cut filter on at all times, which will
block the infrared light from reaching the sensor so that the colors are not distorted.
• Night Mode: The camera switches the IR cut filter off to allow the infrared light to
pass through. This helps the camera to see more clearly in low light conditions.
• Synchronize with Digital Input: The camera automatically removes the IR cut filter
when DI triggers.
• Schedule Mode: The camera switches between day and night mode based on a
specific schedule. If selected, enter the starting and ending time for the day mode.
Note that the time format is [hh:mm] and is expressed in 24-hour clock time. By
default, the starting time and ending time of day mode are set to 07:00 and 18:00.
Light Sensor Sensitivity: Select either Low, Normal, or High sensitivity for the light sensor.
Disable IR LED: Select this option to disable the IR LED. The IR LED automatically switches
on at night (on by default).
D-Link DCS-7110 User Manual

Day and Night Settings

34