Day And Night Settings - D-Link DCS-6116 User Manual

Section 3 - Configuration
Switch to B/W in Night Mode: Select to automatically enable the camera to switch
to B/W night mode.
IR Cut Filter: The IR-Cut Removable (ICR) filter mechanically switches between two
different sensor filters. It provides the best light conditions both during the day and
at night. The following options are:
• Auto Mode: The camera automatically switches between day and night mode
by judging the level of ambient light. This mode is accessible only when the
exposure mode is set to Auto.
• Day Mode: In this mode the camera switches on the IR cut filter at all times,
which will block the infrared light from reaching the sensor so that the colors
are not distorted.
• Night Mode: The camera switches off the IR cut filter to allow the infrared light
to pass through. This helps the camera to see more clearly in low light conditions.
• Schedule Mode: The camera switches between day and night mode based on
a specific schedule. Be sure to enter the starting and ending time for the day
mode. Note that the time format is [hh:mm] and is expressed in 24-hour clock
time. By default, the starting time and ending time of day mode are set to 07:00
and 18:00.
Disable IR LED: Select this box to disable the IR LED. The IR LED automatically
switches on at night. By default the LED automatically switches on at night.
D-Link DCS-6116 User Manual

Day and Night Settings

36