Commands - Siemens AR6181-MS Operating Instructions Manual

Setting up
3.2.7

Commands

16
Siemens Building Technologies
Fire Safety & Security Products
Protocol frame
1
command
Command: 1 byte ASCII, see: 5.2.5.11 Commands
Response of reader:
1
command
Data: The response of the reader can be only a short acknowledge like OK or NOK
or any more or less long information you ask for.
Receipt: Positive acknowledge:
Negative acknowledge: Error message as text information
To read out the actual setting information / parameters only send the command
without any parameter to the selected reader. Each command have to be entered
separately and confirmed by ENTER.
A Application ID (A A0 A1 A2) 3byte Hex-value
F File-ID (F File Block Start End)
N DESFire EV1 key position (N Number)
O
Output length (4/7byte) Serial number (O 0/1)
R Reset to factory defaults
T Transponder type – Activation (T 0 1)
V
Version
S Switch/display Setup
K Keys (K[A|B] X1 X2 X3 X4 X5 X6)
K Key (C C1 C2 C3 ....... C14 C15 C16) for DESFire EV1 transponder only
B ID-Number (B Block Start End), three blocks per sector to calculate!
L LEDs ( red green yellow buzzer, 1=on/0=off)
D Impulse/gaP times (D Itime Ptime) or Bit clock for Magstripe (D Bclock)
U
UCI-Configuration
H Recalculation decimal -> hexadecimal (H number)
Q Termination and saving of changes
ESC Termination without saving
All numbers are in Hex, except the Impulse, Gap and Bit clock times.
2 ... n-1
parameter end character (CR = 0x0D)
2 ... n-1
data end character (CR = 0x0D)
„>" i.e.: after parameter is changed (Prompt)
n
n
02.2010