Accessories - Gilson PIPETMAN P20 User Manual

6. liquid should never enter the tip holder; to
prevent this:
○
press and release the push button slowly
and smoothly,
○ never turn the pipette upside down,
○ never lay the pipette on its side when
there is liquid in the tip.
7. If you use the same tip with a higher volume,
pre-rinse the tip.
8. For volatile solvents you should saturate the
air cushion in your pipette by aspirating and
dispensing the solvent repeatedly before
aspirating the sample.
9. When the temperature of the liquid is
different from the ambient temperature,
pre-rinse the tip several times before use.
10. You may remove the tip ejector (refer to
Changing the Tip Ejector
aspirate from very narrow tubes.
11. After pipetting acids or other corrosive
liquids that emit vapors, remove the tip
holder, rinse the piston, O-ring, and seal with
distilled water. For the P1000 model, use a
specific tip holder equipped with a filter to
increase the lifetime of the piston (refer to

ACCESSORIES

12. Do not pipette liquids with temperatures
above 70 °C or below 4 °C. The pipette can
be used between + 4 °C and + 40 °C but
the specifications may vary according to
the temperature (refer to the IsO 8655-2
standard for conditions of use).
10
|
PIPETTING PIPETMAN® ClAssIC
on page 15) to
on page 11).
Chapter 4
ACCESSORIES
To make pipetting more comfortable and more
secure, Gilson has developed several accessories:
Pipette stands allow users to store pipettes
vertically to avoid the possibility of liquid running
back into the pipette.
DEsCRIPTION
CARROUSEL™ Pipette
stand (7 pipettes)
TRIO™ stand (3 pipettes)
SINGLE™ pipette holder
To identify or personalize your pipette, Coloris™
clips are available:
DEsCRIPTION
COLORIS™ clips (mixed colors set of 10)
COLORIS™ clips (red, set of 10)
COLORIS™ clips (yellow, set of 10)
COLORIS™ clips (green, set of 10)
COLORIS™ clips (blue, set of 10)
COLORIS™ clips (white, set of 10)
With The JIMMY™, hands free microtube opener,
you can open both snap-cap and screw-cap
microtubes.
DEsCRIPTION
THE JIMMY™ (set of 3)
To protect the piston when pipetting corrosive
liquids, you can use a specific tip holder and filter
for the model P1000:
DEsCRIPTION
Corrosion protection kit
(tip holder + a bag of 10 filters)
PIPETMAN® ClAssIC
PART NUMBER
F161401
F161405
F161406
PART
NUMBER
F161301
F161302
F161303
F161304
F161305
F161306
PART NUMBER
F144983
PART NUMBER
F144570
|
UsER's GUIDE
11