Installing The Copier - Ricoh D177 Service Training

 Basically, this is very simple.
 Remove packing materials.
 Remove the seals from the PCDUs.
 Install the toner bottles.
 Developer is pre-installed in the machine before shipping.
 Also, developer is also pre-installed in the service parts for
 This means that there are no procedures for removing old
 If you install an optional paper tray unit at the same time,
put the machine on the paper tray unit first. Then install the
machine and other options
Slide 25
Note that the following steps from Met-C1ab installation are deleted for the new
models:
 Connect the PCDU harnesses.
 Rotate two levers on the ITB clockwise until they point down.

Installing the Copier

» When the machine is switched on for the first time, toner is
sent to the hopper automatically. It takes about 5 minutes.
the PCDU and development unit.
developer and installing new developer.
25
Met-C1yz Training