Ricoh D177 Service Training page 30

Front

These units are installed below the copier.

Always join the copier to the tray unit with one screw. Use one of the connecting brackets
as a screwdriver. Do this immediately after you put the copier on top of the tray unit.
 At the front of the machine, pull out the copier's 2
 At the rear of the machine, at two locations.

Then lock the casters of the paper feed unit.

Finally, check the registration with SP mode as explained in the installation procedure.

Paper size is set as shown below when the machine is shipped from the factory.
 NA: LT LEF
 EU, AA, CHN: A4 LEF

The paper size can be changed to A4 or LT. First, adjust the side fences, then change SP5-
181-007
 0: A4, 1: LT
Slide 30
 There is no space to use a normal screwdriver, so we must use one of the
connecting brackets to attach the screw.
Options
Paper Tray Units
nd
tray and attach the bracket.
30
Met-C1yz Training
Rear