Printed Circuit Board K - ELNA eXpressive920 Service Manual

Setscrew
Printed circuit board
A relay (30-pin)
Printed circuit board
A relay 6-pin)
Printed circuit board
A relay (26-pin)
Replacing Electronic Components
Circuit board K schematic

Printed circuit board K

NOTE:
Do not disconnect the connectors by pulling on cord.
To disconnect the connectors, grasp the connector, not the
cord.
To remove:
1. Remove the front cover (see page 5).
2. Disconnect the connectors from the circuit board K.
3. Remove the setscrews (3 pcs), and the circuit board K.
To attach:
Follow the above procedure in reverse.
Slide volume
Printed circuit board L1
Printed circuit board F
11
Setscrew
Printed circuit board L2