Setting The Race Timer; Using The Race Timer - Raymarine i70 Installation & Operation Instructions

11.1 Setting the Race Timer

The Race Timer is used to show the time elapsed
since the start of a race. The Race Timer has 3
countdown timers. When a timer count down is
complete (reaches zero) then the Race Timer will
start to count up.
If the Race Timer has not been added as a Favorite
Page then it can be accessed from the Data (Quick
View) menu: Menu > Data (Quick View) > Time
> Race Timer.
With the Race Timer page displayed:
1. Press the Menu button.
2. Select Quick Options.
3. Select Adjust start timers.
4. Select a start timer
5. Use the Up and Down buttons to adjust the timer
to the required value.
6. Select Save.
7. Complete steps 4 to 6 for each start timer you
want to adjust.
70

11.2 Using the Race Timer

With the Race Timer page displayed:
1. Select Start.
The first star timer will begin to count down,
audible beeps are sounded as follows:
• Double beep every minute.
• Beep Three times at the start of the last 30
seconds.
• Beep every second for the last 10 seconds.
• Beep for two seconds when the timer reaches
zero
2. You can select Skip to skip to the next start timer.
With the third start timer counting down you can
select Count up to start the timer counting up
from zero.
3. You can stop the start timer count down by
selecting Stop from the Quick Options menu.
4. When stopped, you can resume the count down
by selecting Resume.
5. The Race Timer page can be reset by selecting
Reset Timer from the Quick Options menu.
Note: You can view other Favorite pages and
menus whilst the Race Timer is running.