Description Of The Side-Trimmer - Watkiss P2T User Manual

1 - Introduction to the Watkiss P2T 2-Knife Trimmer - Description of the Side-Trimmer
Installation
Your Side-Trimmer must be installed by a Watkiss approved service engineer.
Special knowledge is needed to install the machine.
CAUTION: Only connect the machine to a mains power supply of the cor-
rect voltage with a good earth-connection. The correct machine-voltage is
shown on the label at the mains power supply input on the rear of the
machine. If the machine is connected to the wrong supply, the warranty is
cancelled.
How to Get Help
If you have any questions or problems, refer to the problem solving section in
this manual (see "Error Conditions, Problems and Solutions" on page 25). Con-
tact your supplier for further help.

Description of the Side-Trimmer

Introduction
The Watkiss Side-Trimmer completes the booklet-making process by trimming
the top and bottom edges of the book. The fore-edge of the book is already
trimmed by the booklet maker, so this additional module provides a profes-
sional solution for full bleed printed work.
FIGURE 1. Side-Trimmer
2
P2T Side-Trimmer
Watkiss P2T 2-Knife Trimmer User Manual