4 - Standard Tasks - Remove and re-fit the Side-Trimmer Book Supports
Step 4 - remove the outer book supports
There are two outer book supports.
Remove one at a time.
Hold each end of the outer book support
and lift upwards.
Remove the outer book support through
the top of the machine.
Repeat with the other outer book sup-
port.
Procedure - Refitting
Step 1 - preparation
Rotate the Side-Trimmer away from the
booklet maker.
Use the mains ON/OFF switch to turn
OFF the Side-Trimmer.
Look through the top window of the
Side-Trimmer.
Note the position of the pivot-bearings.
If the pivot-bearings are not visible:
There is enough space to fit the book
supports.
• Open the top cover of the Side-
Trimmer.
• Go to "Step 2 - fit the inner and
outer book supports".
If the pivot-bearings are visible:
•
Use the mains ON/OFF switch to
turn ON the Side-Trimmer.
Look through the top window of the
•
P2T. The pivot-bearings will move.
When the pivot bearings are not
•
visible, then turn off the P2T.
Open the top cover of the Side-
•
Trimmer.
Go to "Step 2 - fit the inner and
•
outer book supports".
Watkiss P2T 2-Knife Trimmer User Manual
Outer book support
See "Move the Side-Trimmer" on
page 16.
See "Turn On the Side-Trimmer" on
page 5.
See Figures 16 and 17.
See Figure 17 on page 18
See Figure 16 on page 18
21