Standard Tasks; Introduction; Adjust The Side-Trim Offset - Watkiss P2T User Manual

Standard Tasks

CHAPTER 4

Introduction

This chapter describes the standard tasks that are needed in the day-to-day
operation of your Side-Trimmer.

Adjust the Side-Trim Offset

Introduction
By default, the book is side-trimmed by an equal amount on each side. The
side-trim dimension is automatically calculated to trim 2.5mm from each side.
For example, if the book is 210mm wide, the default trim is 205mm. This side-
trim dimension can be changed. Touch
' - ' to adjust the
The side-trim can be offset from the centre line by a maximum of 40mm,
dependent on how much is to be trimmed. The machine will not permit a setting
that conflicts with the stitch position. Change the stitch pitch if necessary (see
"Adjust the Side-Trim Offset" on page 11).
If the
the same orientation as the book delivery out of the Side-Trimmer.
Watkiss P2T 2-Knife Trimmer User Manual
.
TRIM SIZE
is changed, the icon changes to show the setting. The icon is
TRIM OFFSET
and then touch '+' or
BASIC > SIDE TRIM
11