Paper Jams; Change The Fuses - Side-Trimmer - Watkiss P2T User Manual

5 - Error Conditions, Problems and Solutions - Paper Jams

Paper Jams

1. Open and then close the top cover of the side-trimmer.
2. Then, if necessary, open the top cover of the side-trimmer and check for
paper trimmings or obstructions. Close the top cover of the side-trimmer.
3. If the message still does not clear, use the side-trimmer mains ON/OFF
switch. Turn the side-trimmer OFF, wait at least 5 seconds and then turn the
side-trimmer ON.
If the problem continues, then call your service engineer.

Change the Fuses - Side-Trimmer

Introduction
The Side-Trimmer has two fuses at the power input connector. See Figure 2 on
page 3.
If either fuse is broken, the Side-Trimmer will not operate.
WARNING: Turn OFF the machine and remove the mains power supply
cable before you change the fuses. This machine uses two fuses in parallel.
WARNING: To avoid the risk of fire, replace fuses using only the same type
and rating.
Fuse Description
• 7A, HRC Quick acting, F
• Part Number 730-018
Procedure
1. Turn OFF the Side-Trimmer.
2. Disconnect the Side-Trimmer from the power supply.
3. Check each fuse.
4. If the fuse is broken then replace with a fuse of the correct specification.
Result
If the fuse breaks again, then call your Watkiss service engineer.
Watkiss P2T 2-Knife Trimmer User Manual
33