Table of Contents
Advertisement
5 - Error Conditions, Problems and Solutions - Quality Problems
Side-Trimming problem - the book is not trimmed to the correct size
Is
SIDE TRIM
Yes No
Is the correct trim size entered in the touch screen? Make sure the size is at least
2mm less than the book size.
Yes No
Open and then close the top cover of the side-trimmer. Wait for the side-trimmer
to reset. Does the problem continue?
Yes No
Turn off the Side-Trimmer at the mains ON/OFF switch. Wait for 5 seconds and
then turn on the Side-Trimmer. Does the problem continue?
Yes No
Call your service engineer.
Side-Trimming problem - the book is only trimmed on one side
This problem is normally caused by incorrect set-up. If the side-trim offset is
slightly too large, only one side is trimmed.
Is
AUTO
No
Open and then close the top cover of the side-trimmer. Wait for the side-trimmer
to reset. Does the problem continue?
Yes No
Turn off the Side-Trimmer at the mains ON/OFF switch. Wait for 5 seconds and
then turn on the Side-Trimmer. Does the problem continue?
Yes No
Call your service engineer.
Watkiss P2T 2-Knife Trimmer User Manual
turned on?
Turn on the
.
SIDE TRIM
Enter the correct size in the touch screen.
Further action is not needed.
Further action is not needed.
turned off in the
SIDE TRIM
Yes
Set
to
.
SIDE TRIM
AUTO
Does the problem continue?
Yes No
Further action is not needed.
If you need to use a custom trim size, enter the trim dimension in the
window. Make sure the size is at least 2mm less than the
SIDE TRIM
book size.
Further action is not needed.
Further action is not needed.
window?
27
Advertisement
Table of Contents
