Charging With Ac Adaptor - Projecta IS1500 Instruction Manual

VEHICLE JUMPSTARTING INSTRUCTIONS
NOTE: Instructions for negatively earthed vehicles only.
1. Charge your jumpstarter for 24 hours prior to first use and as soon as possible after each use.
2. Before making any connections, check the jumpstarter battery status by pressing the red
BATTERY STATUS button:
Green LED:
Yellow LED:
Red LED:
Flash Red LED: Need to be recharged immediately.
3. Turn your vehicle's ignition to OFF before connecting the jumpstarter's clamps to your vehicle.
4. Connect the red positive (+) clamp to the positive (+) terminal of the vehicle battery, then
connect the black negative (-) clamp to the negative (-) terminal of the battery or a non-moving
metal part of the engine block. DO NOT CONNECT TO FUEL LINE. Always double check you
have proper connections.
5. Check Jumpstarter Status LED:
Red: If illuminated check that the vehicle being jumpstarted is 12V, or the jumpstart
cables are incorrectly connected onto the vehicle battery. This jumpstarter is suitable
for 12V vehicles only.
Green: Ready to jumpstart.
None: If neither LED is illuminated, check that the clamps are correctly connected with good
contact. If the LED's remain unilluminated it may indicate that the vehicle's battery
is below 2.6V, the jumpstarter will only activate when connected to a battery above
2.6V. In this circumstance ensure all connections are correct and then press the
OVERRIDE button for 2 seconds to engage the jumpstarter.
6. Turn the vehicle's ignition to ON and start the vehicle.
7. After the engine has started leave the clamps connected for 40 seconds to allow the jumpstarter
recovery to occur (optional). Then disconnect the black clamp and then the red clamp.
8. Recharge jumpstarter.
Note: With the use of RRT the jumpstarter does not require charging during the working day,
however while not it use it should stored on the docking station to increase the life by 10–20%

CHARGING WITH AC ADAPTOR

IMPORTANT: DO NOT POWER ANY APPLIANCE FROM THE JUMPSTARTER WHILE IT IS BEING
CHARGED USING THE AC CHARGER.
1. To charge, plug the output end of the AC adaptor into the charging socket (back of charging
dock) and connect the AC adaptor to a 240VAC outlet and turn it 'ON'.
2. The Battery Status LED will illuminate orange when charging and green when the jumpstarter
is fully charged. The jumpstarter will automatically stop charging and the jumpstarter will
initiate maintenance charge mode keeping the battery fully charged and ready for use
without the risk of overcharging.
Charging time: 4–6 hours if the battery is down to 50% of its capacity.
WHEN TO CHARGE
To prolong the life of your jumpstarter battery it is recommended to charge the jumpstarter
after each use. If the jumpstarter is not being used, it is recommended to leave the
jumpstarter permanently on charge ensuring the battery is always maintained fully charged
and ready for use. It is recommended to charge the jumpstarter before the first use as the
jumpstarter is shipped only partially charged.
6
Full Charge. Ready to use.
Medium charge. Ready to use, but recharge recommended.
Low charge. Need to be recharged and Not recommend to use.