Checking Initial Operation - Omron C200HE-CPU11 Installation Manual

Checking Initial Operation

4-2

Checking Initial Operation

1, 2, 3...
82
After the Programming Console has been connected, it can be used to check
initial C200HX/C200HG/C200HE operation. Make sure that the Programming
Console is properly connected and that the correct power supply is being pro-
vided, and then follow the procedure outlined below.
1. Check to be sure that the Programming Console is in PROGRAM mode.
2. Turn on the power to the PC and check the CPU Unit indicators. The green
POWER indicator should light.
3. Check the Programming Console display and input the password (Clear
and then Monitor Keys). If operation is normal, the display should appear as
shown below.
Indicates the mode set by the mode selector switch.
Note If the mode is not indicated, turn off and restart the power supply.
4. After checking PC operation, turn off the power. If operation is not normal,
refer to 5-1 Troubleshooting.
MONITOR
RUN PROGRAM
<PROGRAM>
PASSWORD
<PROGRAM>
Section 4-2
BZ