Din Track Mounting - Omron C200HE-CPU11 Installation Manual

Installation Environment
Backplane Insulation Plates
Insulation Plates for CPU Backplanes
Insulation Plates for CPU Backplanes

3-1-5 DIN Track Mounting

If there is an electric potential difference between grounds when devices are
wired separately, then use a Backplane Insulation Plate. There are four models
available, corresponding to the number of slots in the Backplane. The dimen-
sions at locations A, B, C, D, and E are shown below in millimeters for each Back-
plane Insulation Plate model.
135 (118) 110
Specifications p
For 3 slots
For 5 slots
For 8 slots
For 10 slots
Specifications p
For 3 slots
For 5 slots
For 8 slots
For 10 slots
The PC may be mounted using DIN track if desired. This type of mounting is not
required, and the PC may be directly mounted to any sturdy support meeting the
environmental specifications (refer to Appendix B Specifications). If you want to
mount the PC on DIN track, you can order a DIN Track from OMRON (refer to
Appendix B Standard Models). DIN Tracks come in the two heights shown
below.
Note Never use DIN Track to mount Backplane in locations subject to vibration.
M4 screws for mounting to PC
(4/5 places)
(B)
C
D
(A)
(E)
Model
E
C200H-ATT31 261
C200H-ATT51 331
C200H-ATT81 436
C200H-ATTA1 506
Model
E
C200HW-ATT32 190
C200HW-ATT52 260
C200HW-ATT82 365
C200HW-ATTA2 435
Section 3-1
5-dia. holes for mounting
Base Insulation Plate
(4/6 places)
6
12 dia.
5 dia.
10
Dimensions (mm)
D C B
210 --- ---
280 --- ---
385 --- ---
455 227.5 270.5
Dimensions (mm)
D C B
140 --- ---
210 --- ---
315 --- ---
385 --- ---
A
246
316
421
491
A
175
245
350
420
55