Table of Contents
Advertisement
Pre-operation checks
Push the blower switch to operate the blower
and ventilate the engine compartment for at
least 4 minutes.
Navigation and anchor lights switch
check
Push the navigation and anchor lights switch
and check that the bow light and stern light
come on.
(1) Install the stern light. (See page 57 for in-
formation on the stern light.)
(2) Push the top of the navigation and anchor
lights switch and check that the bow light
and stern light come on.
1
CTSY
NAV/ANC
LIGHTS
1
Navigation and anchor lights switch
2
1
Bow light
2
Stern light
84
HORN
1
(3) Push the bottom of the navigation and
anchor lights switch and check that only
the stern light comes on.
(4) Put the navigation and anchor lights
switch in the middle position and check
that the bow light and stern light are off.
(5) Remove the stern light.
Horn switch check
Push the horn switch and check that the horn
sounds.
CTSY
NAV/ANC
LIGHTS
1
Horn switch
Engine shut-off cord (lanyard) check
Make sure that the engine shut-off cord (lan-
yard) is not damaged. If the cord is damaged,
replace it. WARNING! Never try to repair
the engine shut-off cord (lanyard) or tie it
together. The engine shut-off cord (lan-
yard) may not pull free when the operator
falls off, allowing the boat to continue to
run and cause an accident.
1
HORN
Advertisement
Table of Contents
