Blower Checks (212X / 212S / 212); Navigation And Anchor Lights Switch Check (Ar210 / Sx210) - Yamaha AR210 2020 Owner's/Operator's Manual

Push the blower switch to operate the blow-
ers and ventilate the engine compartment for
at least 4 minutes.

Blower checks (212X / 212S / 212)

WARNING
Gasoline vapors can explode. Before
starting the engines, check the engine
compartment for gasoline, gasoline va-
pors, and loose electrical connections,
and then operate the blowers for at least 4
minutes. Do not start the engines or oper-
ate the blowers if you can smell gasoline
vapors in the engine compartment or if
there are any loose electrical connections.
Contact a Yamaha Boat Dealer if there is a
problem you cannot locate or correct.
Make sure that the blowers operate properly.
1
1 Blower
(1) Tap the "Blower" button and check that
the blowers operate.
Pre-operation checks
Dock
Interior
Navigation
Anchor
1 "Blower" button
(2) Tap the "Blower" button to turn off the
blowers.
Navigation and anchor lights switch
check (AR210 / SX210)
Make sure that the bow light and anchor light
operate properly.
The procedure for setting up the anchor light
varies according to the model. See the page
indicated below for your boat.
SX210: See page 106.
TIP:
SX210: Before operating the boat in daylight
hours after checking the navigation and an-
chor lights, store the anchor light.
AR210
2
1 Bow light
2 Anchor light
1
Ballast
Blower
Bilge
1
139