Blower Switch Check; Navigation And Anchor Lights Switch Check - Yamaha AR195 Owner's/Operator's Manual

Pre-operation checks

Blower switch check

WARNING
Gasoline vapors can explode. Before
starting the engine, check the engine com-
partment for gasoline, gasoline vapors,
and loose electrical connections, and then
operate the blower for at least 4 minutes.
Do not start the engine or operate the
blower if you can smell gasoline vapors in
the engine compartment or if there are any
loose electrical connections.
Contact a Yamaha Boat Dealer if there is a
problem you cannot locate or correct.
Make sure that the blower operates properly
when the blower switch is pushed.
BILGE BLOWER
1 Blower switch
1
1 Blower
90
1
Push the blower switch to operate the blower
and ventilate the engine compartment for at
least 4 minutes.
Navigation and anchor lights switch
check
Push the navigation and anchor lights switch
and check that the bow light and anchor light
come on.
(1) SX195/SX190: Install the anchor light.
(See page 64 for information on the an-
chor light.)
(2) Push the top of the navigation and anchor
lights switch and check that the bow light
and anchor light come on.
1
CTSY
NAV/ANC
LIGHTS
1 Navigation and anchor lights switch
AR195/AR190
2
1 Bow light
2 Anchor light
HORN
1