Configure Wrr Queuing; Configuration Procedure; Configuration Examples - HP A5120 EI Series Configuration Manual

Configure WRR queuing

Configuration procedure

Follow these steps to configure WRR queuing:
To do...
Enter system view
Enter interface
view or port
group view
Enable WRR queuing
Configure the scheduling
weight for a queue
Display WRR queuing
configuration information

Configuration examples

Network requirements
1.
Enable WRR on port GigabitEthernet 1/0/1.

Assign queues 0 through 7 to the WRR group, with their weights being 1, 2, 4, 6, 8, 10, 12, and

14, respectively.
Configuration procedure
2.
# Enter system view.
<Sysname> system-view
# Configure WRR queuing on GigabitEthernet 1/0/1.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wrr
[Sysname-GigabitEthernet1/0/1] qos wrr 0 group 1 weight 1
[Sysname-GigabitEthernet1/0/1] qos wrr 1 group 1 weight 2
[Sysname-GigabitEthernet1/0/1] qos wrr 2 group 1 weight 4
[Sysname-GigabitEthernet1/0/1] qos wrr 3 group 1 weight 6
[Sysname-GigabitEthernet1/0/1] qos wrr 4 group 1 weight 8
[Sysname-GigabitEthernet1/0/1] qos wrr 5 group 1 weight 10
Use the command...
system-view
Enter
interface interface-type interface-
interface
number
view
Enter port
port-group manual port-group-name
group view
qos wrr
qos wrr queue-id group 1 weight
schedule-value
display qos wrr interface [ interface-
type interface-number ] [ | { begin |
exclude | include } regular-expression
]
43
Remarks
—
Use either command.
Settings in interface view take
effect on the current interface;
settings in port group view take
effect on all ports in the port
group.
Optional
By default, WRR queuing is
enabled.
Required
By default, byte-count WRR is
used, and the weights of queues
0 through 7 are 1, 2, 3, 4, 5,
9, 13, and 15.
Optional
Available in any view.