Configuration Approaches And Task List; Configuring Sp Queuing; Configuration Procedure; Configuration Example - HP 6125XLG Configuration Manual

queue in a WFQ group and then the traffic beyond the minimum guaranteed bandwidths for the queues
in the WFQ group according to the configured weights. The two WFQ groups are scheduled at a 1:1
ratio.

Configuration approaches and task list

Tasks at a glance
(Required.) Perform one of the following tasks to configure per-queue congestion management:
•

Configuring SP queuing

•

Configuring WRR queuing

•
Configuring WFQ queuing
•
Configuring SP+WRR queuing
•
Configuring SP+WFQ queuing
Configuring SP queuing

Configuration procedure

To configure SP queuing:
Step
1. Enter system view.
2. Enter interface view.
3. Configure SP queuing.

Configuration example

Configure Ten-GigabitEthernet 1/1/5 to use SP queuing:
# Enter system view
<Sysname> system-view
# Configure Ten-GigabitEthernet 1/1/5 to use SP queuing.
[Sysname] interface ten-gigabitethernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] qos sp
Configuring WRR queuing
Configuration procedure
To configure WRR queuing:
Command
system-view
interface interface-type
interface-number
qos sp
46
Remarks
N/A
N/A
The default queuing algorithm on an
interface is WRR queuing.