Defining A Class - HP A5120 EI Series Configuration Manual

Figure 4 QoS policy configuration procedure
Apply the
policy to an
interface

Defining a class

To define a class, specify its name and then configure the match criteria in class view.
Follow these steps to define a class:
To do...
Enter system view
Create a class and enter
class view
Configure match criteria
Define a class
Define a behavior
Define a policy
Apply the policy
Apply the
Apply the
policy to
policy to a
online
VLAN
users
Use the command...
system-view
traffic classifier tcl-name
[ operator { and | or } ]
if-match match-criteria
Apply the
Apply the
policy
policy
globally
globally
Remarks
—
Required
By default, the operator of a class is AND.
The operator of a class can be AND or OR.

AND: A packet is considered belonging to a
class only when the packet matches all the criteria
in the class.

OR: A packet is considered belonging to a class
if it matches any of the criteria in the class.
Required
For available match criteria, see
17
Table 2.