Connections For Analog Out (Dti 1000 Only); Power Supply - Ametek DTI 100 User Manual

5.2.2

Connections for analog out (DTI 1000 only)

The voltage output should be connected to a measuring device as shown in the figure below:
Use the ground terminal (see the figure "Overview" section 3, pos. 3) for the cable shields in
order to reduce noise.
5.2.3

Power supply

The DTI is supplied with 8 1.5 Volt batteries as standard. When the battery voltage is low
following message will appear:
This message will only appear one time after the DTI has been switched on, and is removed
by pressing the key <Menu/Enter> or <Reset/Select>. The DTI is still able perform accurate
measurements a little while longer.
The batteries are placed in the two battery holders shown in the figure below:
It is also possible to supply the DTI from a mains adapter at the connector shown in the
figure above. The mains adapter can be supplied by AMETEK.
100975 05
BATTERY LOW
PRESS ANY KEY
11-06-2001 11/32