Operation; Operating Area; Connection Of Sensors - Ametek DTI 100 User Manual

5

Operation

5.1

Operating area

Both of the DTI models are intended for use in areas which meet the following:
Temperature range
Humidity
Protection class
WARNING: Do not use in hazardous areas!
5.2.1

Connection of sensors

The sensor should be connected to the terminals as shown in the figure below:
Use the ground terminal (see the figure "Overview" section 3, pos. 3) for the cable shields in
order to reduce noise.
The connector type to extra connector on DTI-1000 is: LEMO FFA 1S 304 CNAC.
10/32
: 0°C/32°F to 50°C/122°F
: 0% to 90%
: IP20
11-06-2001 100975 05