Control Screen - LulzBot mini User Manual

Pausing Mid-Print
You will notice after you click the print button through Cura, it will
change to a pause button. When activated, it will pause your print and
automatically move your print head away from your object. This will allow
color changes or material changes mid print.
Automatic Bed Leveling
Before each print your Mini will go through a wiping and a probing
procedure in order to determine the slope/tilt of your bed. If your nozzle is
dirty or not cleaned properly, this will prevent the printer from being able to
create an electrical contact with the corners. Your Mini will automatically
retry the wiping and probing procedure if this happens, up to a maximum of
three times. If three consecutive wipes and probes have failed, the printer
will stop and a warning will sound.
a failed probe, update your firmware.
can be found in section 4.3 on page 64. If probe failures are happening
consistently, you should replace the wiping pad and/or adjust your wiping
and probing temps for that specific filament. See section 2.10 on page 48
2.4. STARTING YOUR FIRST PRINT
Figure 2.12: Control Screen
If your Mini does not re-wipe after
33
Directions for updating firmware