Customize Cut Sheet Tof; Customize Cut Sheet Bottom Margin; Customize Cut Sheet Left Margin - Tally Dascom 1145 User Manual

Tally Dascom 1145/1125+
5. At this stage:
If Load/Eject is pressed, an asterisk "*" is appended to "Yes" and you should repeat the
procedures for form length measurement as mentioned. Or,
If you input "Exit", the printer saves the measurement value and proceeds with the next
customized setting.

6.2 Customize Cut Sheet TOF

1. After you follow through all the steps in 6.1 or you input "Next" in step 3 in 6.1, the printer
prompts:
Top Margin
2. You may skip to other customized settings by pressing "Next" or "Back". Once you press
"OK" to continue with customization of cut sheet TOF, the printer prompts:
Press any key to eject current page, load paper in the Fanfold paper path, and then
proceed as follows:
[TEAR] = -(1/72) inch, [LF] = +(1/72) inch, [LOAD/EJECT] = OK, [ONLINE] = Exit, [ONLINE] +
[LOAD/EJECT] = Save and restart the printer.
3. Follow the given prompt to unload the conversation form. Ensure the lever is at
position. Then press the Load/Eject key to load fanfold paper from tractors. The top
edge of the form initially aligns with the printer's tear-off blade. You may input +/- 1/72" to
adjust the TOF position. When you get the desirable TOF, press OK or Exit. The printer
prompts the customized TOF value:
The defined position is: 4.2 mm.
Save the parameter settings ([LOAD/EJECT] or [ONLINE]=OK, [LF]=Next)?
Yes
4. At this stage:
If Load/Eject is pressed, an asterisk "*" is appended to "Yes" and you should repeat the
procedures for form length measurement as mentioned. Or,
If you input "Exit", the printer saves the measurement value and proceeds with the next
customized setting.

6.3 Customize Cut Sheet Bottom Margin

1. After you follow through all the steps in 6.2 or you input "Next" twice in step 3 in 6.1, the
printer prompts:
Bottom Margin
2. The remaining operations are nearly the same as described in section 6.2. The only
difference is to input +/- 1/72" till you get the desirable bottom margin.

6.4 Customize Cut Sheet Left Margin

1. After you follow through all the steps in 6.3 or you input "Next" three times in step 3 in
6.1, the printer prompts:
Left Margin
2. The remaining operations are nearly the same as described in section 6.2. The only
difference is to input +/- 1/72" till you get the desirable left margin.
51