Online State - Tally Dascom 1145 User Manual

Tally Dascom 1145/1125+

4.4 Online State

Function Switch
Name Operation
Tear Off {S1}
LF {S2}
FF [S2]
Load/Eject {S3}
Online {S4}
Setup State [S4]
Clear Buffer
[S4]+{S1}
and Reset
LED
This is valid for tractor mode only. It feeds the form
to the tear-off position. After tearing off the form,
L2, L3 flash
printing starts on the next TOF by pressing any key
or receiving print data from the host.
-
Feeds one line with every press of S2
Pressing this key will feed paper one line forward.
By holding down this key, the printer will initially feed
-
a few lines, then perform a form feed (continuous
paper mode) or eject the form (single sheet mode).
● Load: Automatically loads the paper (according to
path selection) when no paper is on the platen.
- ● Eject: For rear tractor, it retracts the form from the
platen to allow users to install cut sheets. (NOTE:
Users have to toggle the path selection lever.) For
cut sheets, it ejects the form on the platen.
L4
Toggles between Online and Offline states.
Hold the S4 key for 3 seconds. Toggles to 3s Setup
L4
state. Indicated by flashing L4.
● Clears the print buffer. Beeps once upon
completion.
--
● Pressing S1 longer initializes the printer to
default settings. Beeps 3 times upon completion.
20
Function Description