Aquacal HeatWave SuperQuiet SQ120R Installation Manual page 25

Programming for a Relay Switch
Configure heat pump for a relay or flow switch. This can provide automatic pool/ spa thermostat switching.
Press "Up" and
"Down" buttons
simultaneously
until CF1 appears.
Press the "Pool /
Spa" button until
FS2 is displayed.
Once the FS2 feature has been activated the "POOL / SPA" button will no longer
function. The relay or flow switch is used to change between the pool and spa temperature
settings.
Reset to Factory Defaults Settings
CAUTION - Failure to heed the following may result in equipment damage.
Using this option will reset ALL settings to their factory defaults including external controller
l
settings and sensor calibrations. DO NOT perform this operation if unsure of site specific settings or
how to reset them on the heat pump.
If a qualified technician is unavailable, please contact AquaCal
l
AutoPilot, Inc." on page 1.
1. Simultaneously Press "Pool / Spa" button and "Up"
button until the display shows 888 .
2. Release buttons. Reset is complete.
Press "Pool / Spa"
button until LOC
is displayed.
Press the "Up" or
"Down"
"0" - not active
l
"1" - enable
l
Press "Up" or
"Down" to
passcode. Default
is "17".
®
Technical Support. See "Contacting AquaCal
Press "Pool / Spa"
button once.
Page - 22