Aquacal HeatWave SuperQuiet SQ120R Installation Manual page 23

Table 3 - Default Program Parameters Chart
CODE
CFO
dBP
dB5
DEL
dSC
dFd
FS2
JAO
LOC
tSC
Programming for an External Controller
Configure heat pump for external control.
Using JAO interface
Press "Up" and
"Down" buttons
simultaneously
until CF1 appears.
DESCRIPTION
Call-Flex Options
Pool Dead-Band Differential 1°
Spa Dead-Band Differential 1°
Compressor Time Delay
Defrost Sensor
Defrost Delay
Flow Switch / Automatic
Thermostat Switching
Option
External Controller
Service Level Entry Point
Water Sensor
Press "Pool / Spa"
button until LOC
is displayed.
DEFAULT
VALUE
0 Set to off at the factory.
Set at factory. Do not
adjust.
Set at factory. Do not
adjust.
Set to on (at 4 minutes) at
1 (4 minutes)
the factory. Do not adjust.
Factory Set at factory. Do not
Calibrated adjust.
Factory Set at factory. Do not
Calibrated adjust.
0 = "No Switch"
0
1 = "Enable Switch"
0 = "No Controller"
2 = "Two Wire
0 Controller"
3 = "Three Wire
Controller"
50 00 - 99
Factory Set at factory. Do not
Calibrated adjust.
Press "Up" or
"Down" to
passcode. Default
is "17".
RANGE
Press "Pool / Spa"
button once.
Page - 20