Aquacal HeatWave SuperQuiet SQ120R Installation Manual page 18

Electrical Standards
Standards
NFPA 70
NFPA 70 Article 440
NFPA 70 Article 680
IEC 60335-1-2001
IEC 60335-2-40 2006
UL1995 & CSA C22.2
236-05
Table 2 - Standards
Grounding and Bonding
Follow local code requirements for properly grounding and bonding heat pump equipment.
A bonding lug has been provided on the lower right hand corner of the front panel.
l
Surge Suppression
The use of approved commercial surge protectors is strongly recommended.
Sizing the Electrical Service
Refer to equipment data plate for specific information required to size electrical service and over-current
protection of heat pump. Sizing is based on data plate information, wire size, wiring devices, and over-
current protection per applicable local codes and standards. See "Identifying Model Specifications" on page
39.
Page - 15
The electrical installation must conform to the current
version of the NEC, and all applicable local and state
codes
Standard for Safety for Electric Spas, Equipment
Assemblies, and Associated Equipment
Standard for Safety for Swimming Pool Pumps, Filters,
and Chlorinators
Household and similar electrical appliances - Safety -
General Requirements
Household and similar electrical appliances - Safety –
Particular requirements for electrical heat pumps, air-
conditioners, and dehumidifiers
Heating and cooling equipment
Title