Canon MB2100 Series Online Manual page 958

Memory The printer's memory is full because it has sent/received too many documents, or a detailed document.
is full.
Print the faxes stored in the printer's memory or save them on the USB flash drive, and delete them from
the printer's memory.
Document Stored in Printer's Memory
When sending a fax, resend it. If this message still appears, delete the faxes stored in the printer's memo-
ry, divide the faxes for sending, and send them again.
When receiving a fax, have the sender resend the faxes.
Awaiting • The received faxes were not saved on the USB flash drive automatically because the USB flash drive
document was not inserted or because it was not writable.
process-
The received faxes are stored in the printer's memory. Insert the writable USB flash drive, and then
ing.
save the received faxes to the USB flash drive manually.
Saving Document in Printer's Memory to USB Flash Drive
• The received faxes were not forward to the shared folder on the computer because the printer is not
connected with the computer or because the shared folder setting is changed.
The received faxes are stored in the printer's memory. Connect the printer with the computer, and
then forward the received faxes to the shared folder on the computer manually.
Forwarding Document in Printer's Memory to Shared Folder on Computer
Delete the unnecessary fax from printer's memory after saving to the USB flash drive, forwarding to the
shared folder on the computer, or printing.
Deleting Document in Printer's Memory
FAX info Transmission has been canceled because the printer could not detect the recipient's fax device informa-
does not tion or the information did not match the dialed number. This message is displayed when Check RX FAX
match. information in Security control under FAX settings is set to ON.
For details, see
Reception Reception has been rejected because the fax matches the fax rejection condition specified by FAX recep-
rejected. tion reject in Security control under FAX settings.
For details, see
Waiting If the printer receives a fax under one of the following conditions, the printer will not be able to print the
for report reports. When the problem is resolved as described, the reports are printed automatically.
output...
• The amount of remaining ink is insufficient to print a report:
Replace the ink tank.
Replacing Ink Tanks
• Paper has run out:
Load the paper and press the OK button.
• A different size of paper from that specified by Page size in FAX paper settings is loaded:
Load the same size of paper as that specified by Page size, and then press the OK button.
• You pressed the Stop button to cancel printing of a report:
Press the HOME button and select FAX to resume printing of the report.
Preventing Mistransmission of
Rejecting Fax Reception.
Faxes.
958