Arming In Stay Mode - Bosch amax 2100 Operation Manual

AMAX panel
Key switch arming
Users can use a key switch to arm an area.
4
P
To enable/disable this function contact your installer.
RADION RF keyfob arming
Users can use a RADION RF keyfob to arm an area.
4
P
To enable/disable this function contact your installer.
3.1.2

Arming in STAY mode

The STAY mode is used to arm the perimeter and unused parts
of the premises as defined by the installer to detect a would-be
intruder, while at the same time being able to move freely within
an area that is automatically isolated.
Keypad arming
There are two methods to arm the area assigned to your keypad
in STAY mode.
Method 1
4
P
P
Method 2 (quick arm)
4
P
To enable/disable this function contact your installer.
Bosch Sicherheitssysteme GmbH
Activate the key switch.
The AWAY indicator flashes slowly and exit time starts.
After exit time, the AWAY indicator is lit.
Press the arming button of the RADION RF keyfob.
The AWAY indicator flashes slowly and exit time starts.
After exit time, the AWAY indicator is lit.
Enter your code and press [*].
The system beeps twice, the STAY indicator flashes slowly
and exit time starts. After the exit time, the STAY indicator
is lit.
The lights corresponding to all zones programmed as
automatically isolated zones (Interior Instant Zone) begin to
flash and continue until the exit time is finished.
Press and hold [*] until the system beeps twice.
The STAY indicator flashes slowly and exit time starts. After
the exit time, the STAY indicator is lit.
Arming and disarming areas | en
2017.04 | 07 | F.01U.295.569
21